ODO meter page IMMO Page HOME ECU Page
For Removing Crash data
and any stored DTC in the SRS modules, you
will need
special tools to support different cars made/models, those tools can
connect to the
SRS modules, either Via OBD or by wiring
connections on-board, the problem here
you will need to buy many tools to
support the whole cars (SRS modules) of your
interest and this costs too much money and sometimes you will not find the right
tools that fit your needs.
Our Airbag software package
can help you to solve this problem, since all you need is
a good serial programmer to read and save the memory device's dump file of the SRS
modules on-board, or via OBD by using a serial K-Line cable, and then, open the
saved airbag dump file in any of our airbag software (according to the Vehicle
made/model and SRS ID) then run the CLEAN command and save a clean dump file to
be written back to the storage device of the relative SRS module by using the Serial
programmer, plug the SRS module to the car and clean any existed DTCs by a
diagnostic tool, then, airbag warning light will go off and Job Done.
a good serial programmer to read and save the memory device's dump file of the SRS
modules on-board, or via OBD by using a serial K-Line cable, and then, open the
saved airbag dump file in any of our airbag software (according to the Vehicle
made/model and SRS ID) then run the CLEAN command and save a clean dump file to
be written back to the storage device of the relative SRS module by using the Serial
programmer, plug the SRS module to the car and clean any existed DTCs by a
diagnostic tool, then, airbag warning light will go off and Job Done.